基于SERVQUAL的网约车服务质量评价研究

随着“互联网+”的广泛应用以及网约车服务模式的合法化,使我国大城市网约车的服务质量问题愈发暴露出来。为提高网约车服务质量,根据SERVQUAL构建了网约车评价指标体系,并通过AHP研究方法和IPA分析分别对网约车服务影响因素和网约车服务评价指标进行了分析,从而提出网约车服务质量控制策略,对网约车服务质量改善具有一定的参考意义。     

适用船舶自流冷却系统中冷却器的工程设计研究

针对船舶自流冷却系统对冷却器要求的特点,对各种间壁式换热器的优缺点进行了分析,并结合热工理论计算,确定了冷却器宜采用小管径换热管的钛合金管壳式换热器,获得了小管径换热管数量与不同航速、冷却流体流动状态的设计关系,且基于热工计算结果表明了结构优化方向。采用 CFD技术对两管程流体流场进行了数值模拟优化分析,获得了后端管箱封头a/b的最佳值。实船工程试验结果验证了本文分析设计和优化方法的可靠性。     

基于未确知测度理论的隧道施工瓦斯灾害风险评价

选取煤层厚度、煤层瓦斯含量、回风流平均瓦斯浓度、相对瓦斯涌出量、岩石类型、连通封闭性、深度值、隧道跨度、隧道长度、通风风速和涌水量等11项瓦斯灾害指标作为隧道施工瓦斯灾害风险评价指标体系,并建立各指标的等级标准。将序关系分析法(G1)和反熵权法(AEW)运用拉格朗日乘子法确定组合权重,构建各指标的单指标测度函数,并计算出各指标的综合测度评价向量。为了优化未确知测度置信度识别准则,引进集对分析(SPA)关联系数确定各隧道的瓦斯灾害风险等级。并对24个瓦斯隧道进行瓦斯灾害评价,并和FDA法评价结果和现场实测结果进行对比,精度达到91.7%,基本符合实际情况,表明了该评价方法合理有效,可为隧道施工瓦斯灾害评价提供理论参考。     

自升式平台升降装置设计与强度分析

针对自升式平台升降装置长期依赖进口的现状,自主设计研发了400英尺及以上作业水深的自升式平台电动齿轮齿条传动升降装置,并对其关键部件爬升齿轮进行了重点设计及强度分析。通过DNV及相关规范与有限元结果对比的方法对升降装置关键部位在风暴自存工况下进行强度校核,分析其结构强度性。根据方案设计生产升降装置样机,并对试验样机并进行了载荷试验、疲劳试验,试验结果表明,该装置符合设计和使用要求,为自升式平台升降装置设计提供指导与参考。     

铁路客站大跨叠层桁架结构受力分析

跨度52m的钢结构大跨叠层桁架是西安火车站站改工程重要组成部分。通过建立大跨叠层桁架的整体有限元模型,对整体结构进行全面的静力分析和自振特性分析。静力分析着重研究结构整体变形和应力比,分析不同荷载工况作用下结构变形特征;自振特性分析在研究叠层桁架自振特性的基础上,分析改变桁架腹杆形式对结构自振特性的影响。计算结果表明:构件的变形及应力比均满足《钢结构设计规范》(GB50017—2003)的规定,结构整体位移分布一般呈现正对称特征,大跨叠层桁架的最大位移区域位于跨中位置;大跨叠层桁架具有较低的自振频率,腹杆形式的改变对其自振频率的影响不大。     

高速铁路线路参数与线路方案动力分析研究

线路线形条件对高速铁路行车安全性及乘坐舒适性的影响显著增强。我国在制定高速铁路规范时,总结吸收国内外建设及运营管理经验,提出了较高的线形标准。采用动力仿真分析方法对高速铁路参数进行探讨,对高速铁路线路关键参数进行分析,提出线路平、纵断面关键参数合理取值。针对京沈高铁试验段开展更高速度综合实验,对线路线形方案开展动力学分析及评估。提出线路圆曲线、反向曲线夹直线最小长度、竖曲线最小半径关键参数合理取值,可有效减少工程建设投入;通过对京沈高铁试验段开展更高速度综合实验,对线路线形方案开展动力学分析及评估,提出通过增加8 000 m曲线半径超高的方法,提高速度400 km/h列车舒适度。     

Numerical study on the dynamic response of a truncated ship-hull structure under asymmetrical slamming

Dynamic response of ship-hull structure under slamming has tracked widespread attention in the marine structural design. However, our understanding on the dynamic characteristics largely relies on the symmetrical slamming cases. This paper presented a preliminary numerical investigation on the dynamic response of a truncated ship-hull structure under asymmetrical slamming based on the uncoupled CFD-FE method. Asymmetrical slamming loads were predicted through combining the seakeeping analysis and CFD method. In there, three kinds of motions (vertical, horizontal and roll motions) of 2D ship sections were obtained through the seakeeping analysis and then the slamming pressure was predicted through simulating the water entry with various motions based on CFD method. The dynamic response was analyzed through finite element method. Numerical predictions including ship motions, slamming loads and dynamic analysis were validated against published experimental data and numerical calculations. The characteristics of asymmetrical slamming loads were analyzed showing obvious asymmetry in space, and the dynamic characteristic of the ship bow structure was further clarified through discussing the deformation and stress distribution. These results are useful for readers for better understanding the dynamic characteristics of the bow structure under slamming.     

基于可靠性方框图与蒙特卡洛仿真的船舶配电网可靠性分析方法

国船舶工业发展迅速,尤其在近几年迎来了跨越式的发展。船舶建设工业的发展能充分体现一个国家的经济和国防建设水平。但船舶配电网拓扑结构与陆上电网不尽相同,其运行环境非常恶劣,供电连续性和可靠性成为衡量船舶生命力的重要指标,同时也深刻影响大型船舶的平均寿命。因此,可靠性研究在船舶建设中发挥着越来越重要的作用。本研究以典型大型船舶中压配电网结构为研究对象,在全系统元件正常运行时相互独立的情况下,重点研究不可维修与可维修下的系统可靠度、MTBF、可用度、停运时间和失效数等,并进行详细的分析与讨论。首先,本文综合考察各种可靠性分析方法的适用性和准确性,选择利用可靠性框图、最小路集分析法计算并分析不可维修情况下系统的可靠度、平均故障间隔时间等可靠性指标；接着,本文简述了配电网的多种维修任务类型,并采用最小路集法与蒙特卡洛仿真法相结合的方法计算并分析可维修系统的可用度、停电时间、失效数等指标。本文研究结果对船舶配电网的设计、建造、运行和维修等具有积极的意义。     

Costs of air pollutants from shipping: a meta-regression analysis

ABSTRACT

This study estimated the external cost of air pollution from shipping by means of a meta-regression analysis, which has not been made before. Three pollutants, which were included in most of the primary studies, were considered: nitrogen oxides (NO_x), sulphur dioxides (SO₂) and particulate matters with a diameter of max 2.5 micrometres (PM_2.5). All primary studies included damages of health and a majority added impacts on agriculture and estimated the cost of air pollutants by transferring cost estimates from studies on costs of air emissions from transports in Europe. Different regression models and estimators were used and robust results were found of statistically significant emission elasticities of below one, i.e. total external costs increase by less than 1% when emissions increase by 1%. There was a small variation between the pollutants, with the highest elasticity for PM_2.5 and lowest for NO_x. Calculations of the marginal external cost of the pollutants showed the same pattern, with this cost being approximately six times higher for PM_2.5 than for the other pollutants. Common to all pollutants was that the marginal external cost decreases when emission increases. Another robust result was a significant increase in the cost of studies published in journals compared with other publication outlets. These findings point out some caution when transferring constant external unit cost of air pollutant from shipping, which is much applied in the literature, and the cost functions estimated in this study could thus provide a complementary transfer mechanism.     

Traffic impact analysis of inspection area site selection at a foreign trade container terminal

ABSTRACT

To improve the security and efficiency of terminal operations, a key issue for land area layout at a foreign trade container terminal is to plan and design an inspection area. Since it directly affects terminal traffic, while determining inspection area site selection, we should pay a great attention to operations and management of terminal traffic as well as container inspection. This paper employs a system decomposition technique to develop an integrated simulation framework, which enables us to flexibly obtain the whole picture of terminal traffic conditions and evaluate traffic impacts of inspection area site selection. A real-world terminal with typical patterns of land area layout is chosen to carry out a case study, which shows that traffic flow is unevenly distributed on the terminal road network and that the distribution is influenced by truck streams at the terminal. New findings also include: (1) traffic volume at the terminal apron is rather unbalanced in association with the non-continuous utilization of berths; (2) a proper inspection area should be located near the gate if the terminal conditions permit from the perspective of terminal traffic. This work may provide a decision-making reference for the planning and construction of foreign trade container terminals.